Enviroheat 200EH1-14 200L Heat Pump Hot Water System
Model 200EH1-14 · Straight electric swaps where simplicity beats bells and whistles
Enviroheat · pick your size
What are you replacing?
Fully installed in VIC · rebates already off
No obligation · We reply within one business hour
The maths
Where $1,702 of your price disappears
Three separate VIC incentives stack on this unit when you're replacing a electric storage. We lodge every form — you never chase paperwork or wait on a cheque.
How the rebates workInterest-free loan option too
16 certificates
Depends on the unit you're replacing
Running costs
About $1,200 a year back in your pocket
Based on a four-person Victorian household — roughly 4,500 kWh of water heating a year at 30c/kWh. At a COP of 3.39, this unit only needs about 1,327 kWh to do the same job. Run it on the timer through the middle of the day and most of that comes off your roof, not the grid.
Got rooftop solar?
Time the heat pump to soak up your daytime output
Every kWh you self-consume is worth 30c instead of the 3c feed-in you'd get for exporting it — that's the solar saving baked into the numbers below.
Your estimated hot water bill
down from $1,350 on an old electric tank
$1,200
Saved per year vs electric
$630
Saved per year vs gas
1.2 yrs
Payback after rebates
3.2 t
CO₂ avoided per year
Over 10 years
$11,999
Estimate only — your actual bill depends on tariff, climate zone, solar system size and how much hot water the household chews through.
Spec sheet
Every number, straight off the data plate
Manufacturer-published figures. Anything we can't verify is shown as a dash rather than guessed.
- Model number
- 200EH1-14
- Series
- Enviroheat monobloc all-in-one
- Nominal / actual tank volume
- 200 L / 195 L
- Suits household
- 2–3 people
- COP @ 15°C air
- 3.39
- COP @ 7°C air
- 3.04
- Heat-up time
- 4.68 h at 15°C · 5.50 h at 7°C
- Sound power level
- 57 dB
- Net dimensions
- 600 × 629 × 1670 mm (D×W×H)
- Packed dimensions
- 735 × 695 × 1940 mm
- Net / gross weight
- 91 / 103 kg
- STC zones
- Zones 1–4
- Warranty
- 5 yrs tank & compressor parts · 1 yr labour
- System type
- Monobloc air source heat pump (all-in-one)
- Refrigerant
- R134a / 0.9 kg
- Tank construction
- Vitreous enamel lined low-carbon steel
- Corrosion protection
- Two sacrificial magnesium anodes
- Heat exchanger
- Micro-channel condenser wrapped around the tank
- Power supply
- 220–240 V / 50 Hz / single phase, 10 A plug
- Heat pump input power
- 495 W average · 865 W maximum
- Backup element
- 1500 W
- Max input power / current
- 2365 W / 9.85 A
- Standby power
- 35 W
- Default temperature
- 55°C (adjustable 35–75°C)
- Ambient operating range
- -7°C to 45°C
- Sound pressure
- 46 dB(A)
- Tank rated pressure
- 700 kPa (0.7 MPa)
- Ingress protection
- IPX4
- Water connections
- G3/4" F inlet, outlet and safety valve
- Tank capacity
- 200 L
- Suits household
- 2–3 people
Enviroheat monobloc
Simple, tough and plugs into a normal power point
The 200EH1-14 is a no-fuss monobloc — heat pump on top, 195 L enamel-lined tank below, micro-channel condenser wrapped around it instead of a copper coil. It runs on a standard 10 A plug, keeps working down to -7°C, and holds a COP of 3.39 at 15°C air. Supported out of Australia by Southern Cross Water Heating / Consolidated Energy.
Five operating modes
- ECO (off-peak)
- The recommended setting. The unit only runs inside the windows you program — perfect for soaking up cheap off-peak power or spill solar during the day.
- Auto
- Heat pump does the work on its own and only calls on the element when the air's too cold or you've hammered the tank.
- Boost
- Brings the element in with the heat pump for a quick recovery — handy when the in-laws show up and everyone wants a shower.
- Holiday
- Park the system while you're away and tell it what day you're back. It fires up the day before so there's hot water when you walk in.
- Emergency
- If a sensor plays up, holding BOOST for 10 seconds runs the system on the element with full temperature and safety control until a tech gets there — you're never left with cold showers.
Warranty
- Tank cylinder1 year labour
- 5 yrs parts
- Compressor1 year labour
- 5 yrs parts
- Electrical element1 year labour
- 1 yr parts
- Anode, PTR and ECV valves1 year labour
- 1 yr parts
Micro-channel condenser
Refrigerant runs through a micro-channel condenser wrapped around the tank instead of a copper coil. Enviroheat rate it at around 7.5 times the corrosion resistance of copper pipe, and the bigger contact area moves heat into the water faster.
Two sacrificial anodes
Twin magnesium anodes in a vitreous enamel lined tank. Get them checked every few years and swapped at the five-year mark and the cylinder will go the distance.
Standard 10 amp plug
Plugs into a normal 10 A GPO — no dedicated circuit or switchboard work in most swaps, which keeps install costs down.
Runs to -7°C
The heat pump keeps working down to -7°C ambient, so it handles a Melbourne winter morning without leaning on the element all season.
Weathershield included
If it's going in an unsheltered spot, the Enviroheat Weathershield ships with the unit — no extra part to chase up.
Up to 71% cheaper to run
Enviroheat's own figure against a conventional electric storage tank. Pair it with an off-peak or solar timer window and the gap gets bigger again.
The Enviroheat range side by side
| Model | Tank | Suits | COP @15°C | Size (D×W×H) |
|---|---|---|---|---|
| 200EH1-14 | 195 L | 2–3 people | 3.39 | 600 × 629 × 1670 mm (D×W×H) |
| 250EH1-15 | 246 L | 3–5 people | 3.41 | 600 × 629 × 1965 mm (D×W×H) |
Water quality limits for warranty
- Total dissolved solids600 mg/L max
- Total hardness200 mg/L max
- Chloride250 mg/L max
- Magnesium10 mg/L max
Melbourne mains water sits well inside these limits. Bore or tank water needs filtering first, otherwise the tank warranty won't hold.
Straight talk
Our honest take on Enviroheat
- Micro-channel condenser — rated around 7.5× the corrosion resistance of copper pipe
- Runs off a standard 10 A power point, so most swaps need no switchboard work
- Twin sacrificial anodes in a vitreous enamel tank
- Keeps working down to -7°C and comes with a weathershield in the box
- R134a refrigerant, not the newer R290 — GWP is far higher
- COP of 3.0–3.4 sits below the R290 and CO₂ leaders, so fewer rebate certificates
- Labour cover is only 1 year
- Just two sizes — 200 L and 250 L
How it happens
From quote to hot water in about a week
Quick chat
Tell us what you're replacing and where it sits. Fixed price back the same day.
Rebate paperwork
We check eligibility and lodge Solar Victoria, STCs and VEECs for you.
Install day
Old unit removed, new one plumbed and wired. Usually done inside a day.
Aftercare
Warranty claims and servicing handled through us — one number to ring.
Owners
What Victorians say
"Swapped our old electric tank. The bill dropped straight away and the crew sorted every rebate form."
Sarah M. · Melbourne
"Reckoned it'd struggle in winter — it doesn't. Water's hot on frosty mornings and you can barely hear it."
James T. · Geelong
"Price was exactly what was quoted. No surprises, rebates applied upfront. Easy."
Priya K. · Ballarat
FAQs
Questions we get asked
Want this one at $1,443 installed?
Send us a couple of details and we'll confirm your rebate eligibility and lock the price in writing. No sales pressure, no obligation.
Fully installed · incl. rebates
$1,443